When roaming with multi-hulls, it happens that the battens weaken.
The clip I offer for a rabid multi-hive hive is easy to use and reliable in operation. It consists of steel hooks, sliding locks and upper bracket.
At one end of each hook 1, a M8 thread with a length of 30 mm is cut, the other is bent at a right angle of 30 mm. Lock 2 consists of two welded steel pieces of length 35, diameter 1 6 mm. In one of them a hole with a diameter of 9 mm is drilled, which includes a rod with M8 threads, in the other – a hole with a diameter of 7 mm for staple rods. In the same section, two through holes for M6 threads for fixing bolts are drilled.
Staple 3 consists of a steel strip 1 mm thick, 25 mm wide, which is bent to the size of the hive. Two rods with a diameter of 6 mm are attached to it with two rivets. Their length depends on the number of cases. In the middle of the side blocks of the bottom of the hive, holes with a diameter of 8 mm are drilled, where the hooks are inserted.
With the help of sliding locks, I fix the fastener to the desired height and tighten the bolts on the locks and the nuts 4 on the hooks.
The skeleton is on the hive all season. If necessary, it is necessary to loosen the nut 4 on one side, pull the hooks from the bottom of the chisel, turn them forward by 90 њ, and the hive can be disassembled.
Дезинфекция сотов. Как почистить соты.
Fixtures and fixtures